17A E-bike Controller
Features:
Applicable to 250W 350W brushless hub motor.
Only support hub motors with sensors.
36V 48V universal (support two voltages at the same time)
Square wave driver (high efficiency)
KT LCD4 KT LCD5 or LCD3 ebike display stand.
Support 36V or 48V lighting control.
Specifications:
1.Mosfet: 6mosfet.
2. Working voltage: DC 36V or 48V.
3. Rated current: 8A.
4. Low voltage protection: DC30/40 ± 0.5V.
5. Maximum current: 17±1A.
6. Speed adjustment: 1-4.2V.
7. Size: 94*61*36mm.
9 pin female waterproof Motor connector
Main cable: 8 pin female connector waterproof (suitable for 1t4 waterproof cable.)
Battery cable (bullet)
PAS sensor connector: 3-pin waterproof female (Julet)
Pedal Assist Sensor:
Type: Dual Hall PAS Sensor.
KT display setting: C1=7.
Installation method: left.
Voltage: used with 36V and 48V controllers.
Magnets: 12 magnets.
Cable length: 90cm not including sensors and connectors.
Connector: 3 Pin Julet Waterproof Male Connector.
Corresponding braking time: <0.001S.
Corresponding distance: 2-3mm.
Hall electrical life:> 20M times.
1T4 waterproof cable:
Cable length: about 180cm, including the connector.
Connector: 8-pin input waterproof male connector.
Output:
1:5 pin waterproof female head (display)
2: 3-pin waterproof female head (throttle)
3: 3-pin waterproof male head (brake)
4: 3-pin waterproof male head (brake)
Brake lever:
1. Connector: 3 waterproof female hend.
2. Cable length: about 20cm.
3. Application type: mechanical brake.
KT LCD3 Display:
KT LCD3 e-Bike LCD Meter for KT Series Controllers. Only fits KT Series controllers. It is not suitable for other controllers.
1.This electric bike screen connector is not waterproof. It is a 5 pin waterproof male connector.
2.Cable length is about 40cm.
3.Working voltage: DC 24V 36V 48V.
KT LCD4 Display:
e-Bike KT LCD4 LCD display is for KT Series controllers. Only fits KT Series controllers. It is not suitable for other controllers.
1. Dimensions: 19x54x10mm.
2. 24V, 36V, 48V power supply voltage can be automatically identified and supported;
3. Cable length: about 21cm
KT LCD5 Display:
KT LCD5 e-Bike LCD Meter for KT Series Controllers. Only fits KT Series controllers. It is not suitable for other controllers.
1.This electric bike screen connector is not waterproof. It is a 5 pin waterproof male connector.
2.Cable length is about 40cm.
3.Working voltage: DC 24V 36V 48V.
Note:
This ebike waterproof controller conversion kit does not include motor and battery.
If you need ebike motor, please check our recommended product below.
Package includes:
1*1set e-bike waterproof controller.