6V 12V 10A Solar Panel Battery Regler Charge Controller Other Types optional

Store Categories

• Arduino module
  • WEMOS D1
  • ESP series
  • Nodemcu
  • Mega
  • Motor
    • Servo
    • 9V Battery Holder Box ON/OFF
    • TYC motor
    • 28BYJ-48 motor
    • Hollow motor
    • Brushless motor
    • Mobile Coin Flat motor
    • DRIVE/WIRE Stepper motor
    • Other motor
    • Plastic Gears
    • Smart Car and Acessories
    • Stepper Motor
    • Speed Reduction Gear
  • Motor Drive Module
• ICs
  • DIP
  • TO92
  • TO220
  • SOP
  • PLCC
  • QFP
  • Diodes/Rectifiers
  • Cables/Conneectors/PCB/kits
  • Socket?Connector
  • LED?SMT?Light
  • LED?DIP?Light
  • SOT
  • SMD
  • Capacitor
  • Resistor
• Flight Control APM
  • Flight control
  • Drone accessories
• 3D Printer Accessories
  • Jaw Shaft
  • Pump
  • Bearing
  • 3D printers
• Battery
  • Lithium Battery
  • Li-ion Battery
  • Battery Case
  • Lithium battery PCB board
• Electronic Components & tool
  • Electronic tools
  • Diodes/Rectifiers
  • Welding tool
    • Solder paste
    • Thermal paste
    • Soldering Wire
    • Spot Welders
  • Rain Gauge
  • Magnet
  • Connector
  • Tools
    • Repair watch tool
    • Engraver Pen
  • Radio
  • Networking Adapters & Antennas
  • bearing
  • PH Electrode Probe
  • Heatsink
• Module & Development Board
  • Sensor
  • Relay
  • Wireless Module
  • Bluetooth Module
  • WIFI Module
  • DC-DC Power Module (step-down)
  • Breadboard
  • LCD/LED/TFT Display
  • Development Board
  • Signal Generator
  • Amplifier
  • Controller
  • Server Module
  • Digital Thermostat
  • Clock Module
  • Logic board
  • Voltage Regulator
  • Signal Transmitter
  • Voice Module
  • USB Module
  • Amplifier board
• Meter
  • Current Voltage meter
  • Analysis Instruments
  • Tester
• Raspberry/Orange Pi
  • Raspberry Pi
    • Raspberry pi Case
    • Raspberry pi Board
  • Orange Pi
  • Expansion Board
• Fashion/Beauty
  • Beauty
    • Makeup brush
    • Beauty tools
  • Earring/Quartz watches
  • Jewelry
• Auto Parts & Accessories
  • Car Lights
  • Car DVRs
    • Car DVR Camera
    • Car Bumper Set
  • GPS&Accessories
  • Car Electronics
  • Car Audio&Monitor
  • Car Alarm&Security
  • Diagnostic Scan Tool
  • Auto Parts
  • Interior Accessories
  • Exterior Accessories
  • Car Repair&Maintenance
  • Electric Scooters
  • Car Sun visor
  • Car Cradles & Mounts
  • Scanners
  • Fuse Box
  • Grille Logo
  • Inverter
  • Switch panel
  • Rocker Switch
  • Desiccant
• Fashion/Health
  • Thermometer
  • Humidity Thermometer
  • Blood Pressure Monitor
  • Massager
  • Maternal and Child Health
  • Healthy Medical Product
    • Oral Health
    • Smart Wristband
  • Otoscope
  • Fitness
• Motorcycles & Accessories
  • Motorcycle
  • Bicycle Light
• Smart Elecyronics
  • Smart Watch
  • LED Light
    • LED String
    • LED Lamp Base
    • light bulb
  • Cables/Conneectors/PCB/kits
  • Solar Power
  • Dupont Wire
  • Cooling fan
  • Camera
  • Speaker
  • USB Converter Cable
  • Media Player
  • Anti Lost Device
  • Alarm System
  • HDMI
  • Keyboard
  • Bluetooth Receiver
  • Power Banks
    • Power Bank Cases
  • Microphone
  • DIY Kit
  • Adapter
  • Smart Switch
  • PIR Sensor
  • Flashlight
    • USB Flashlight
  • Headset
    • Bluetooth Headset
  • USB Socket Converter
  • Memory
  • Fingerprint Lock
  • TV Box
  • Wireless Devices
  • Electric Charging tool
  • Headphone
  • Games Accessories
  • Screen player
  • Mobile Phone Accessories
  • lighting control
  • Game charger
  • Microscopes
  • Watering Timers & Controllers
  • Clock
  • humidifier
  • projector
  • Tracker
  • Steam brush
  • Translators
  • Insect repeller
  • Electronic scale
  • Plant light
  • Camera bag
• Toys
  • Magic Cube
  • mask
  • RC Cars
    • RC Cars parts
  • RC Drone
    • RC Drone parts
  • Other
  • playing card
• Electronic Cigarettes
• Sports & Outdoor
  • Fishing & Hunting
• Other

Item Description

6V 12V 3A(Suitable for 6V/12V Lead acid/colloid battery)
Regulator
Material: Plastic
Size: 53.4*68*6*22mm
System Voltage: 6V, 12V
Output Current: 3A
Power Range: ≤60W(6V), ≤120W(12V)
Overload, Short Circuit Protection: Yes
No-load loss: ≤5mA
Charge Loop Drop: ≤0.2V
Disharge Loop Drop: ≤0.1V
Protection Degree: IP30
Working Temperature: -30°~55°

Package Included:
1* Solar Charge Controller
1*Manual


6V 12V 10A(Suitable for 6V/12V Lead acid/colloid battery)
Regulator PWM
Specification:
Brand new
Material: Plastic
System Voltage: 6V, 12V
Output Current: 10A
Power Range: ≤60W(6V), ≤120W(12V)
Overload, Short Circuit Protection: Yes
No-load loss: ≤5mA
Charge Loop Drop: ≤0.2V
Disharge Loop Drop: ≤0.1V
Protection Degree: IP30
Working Temperature: -40℃~55℃

Package Included:
1* Auto Solar Charge Controller
1*Manual

12V 10A(Suitable for 12V Lead acid/colloid battery)
Regulato
Description:
Warnings for usage:
- The batteries has stored much energy,please keep the batteries from the short circuit under any circumstances,we strongly recommend connecting the batteries with the fuse.
- Please avoid the short circuit wire and the terminal,for the wire and the terminal may generate voltage two times higher than the rated voltage of the controller.please use the insulated tools while operating the controller. - Because of the equipment work may have a fever, please keep ventilation.The device pay attention to water，moisture，in order to avoid damage to the equipment.
Suitable range:
- The controller is only applicable to solar power, rated voltage of 12v systems, battery of gel batteries, liquid openings or sealed lead-acid batteries.
- note: specifically how much battery charge, see the product model, product can not be adapted to the various systems. Characteristics:
- Equipped with the mcu, artificially controlled.
- Equipped with device to avoid the overcharge, over release, electronic short circuit, over loading, battery inversely connecting, solar battery inversely connecting.
- Use the battery discharge rate characteristics to correct discharge control。
- The series connection pwm circuit is implemented to form the major charging
- Make the voltage loss half of or lower than the diode charging circuit, and the charging efficiency 3%-6% higher than the non-pwm.
- The led shows the batteries current situation to make the customer get the information of the batteries.
- Three operating modes can be selected: normally open mode, the pure light control mode and light control plus timing mode. Package Included:
1*Solar Charge Controller
1*Manual

11.1V 10A(Suitable for 18650/Polymer battery)
Specification:
- Material: Plastic
- System Voltage: 11.1V
- Output Current: 10A
- Power Range: ≤111W
- Overload, Short Circuit Protection: Yes
- No-load loss: ≤6mA
- Charge Loop Drop: ≤0.2V
- Disharge Loop Drop: ≤0.1V
- Protection Degree: IP30
- Working Temperature: -40℃~55℃

Package Included:
1*Solar Charge Controller
1*Manual



11.1V 3A(Suitable for 18650/Polymer battery)
Characteristics of the function:
Working for Li-ion battery’s charging control
Voltage: 11.1V
Current: 3A
Working temperature: -30 ℃-55℃
Equipped with the MCU, artificially controlled.
Equipped with device to avoid the overcharge, over release, electronic short circuit, over loading, battery inversely connecting, solar battery inversely connecting.
Use the battery discharge rate characteristics to correct discharge control.
The series connection PWM circuit is implemented to form the major charging circuit, make the voltage loss 50% or lower than the diode charging circuit, and the charging efficiency 3%-6% higher than the non-PWM.
The LED displayer shows the batteries current situation to make the customer get the information of the batteries.
Three operatiing modes can be selected: normally open mode, the pure light control mode and light control plus timing mode.

Package Included:
1*Solar Charge Controller
1*Manual

Above Install and Method of Using:
Firstly, determine the controller output mode , the device factory default setting is normally open mode .if you need to set for the pure light control mode or light control plus timing mode, you need to open the enclosure through set dip switch, changing the discharge mode
When the key set "on" is 1, the key set "off" is 0, normally open, pure light control
Connecting the battery first. if correctly connected, battery indicator will light
Connecting the wire of the solar panel second. if the connection is correct, the indicator light of “charge”will be on or flash 10 seconds later after laying outside under the sun. otherwise, please check the connection
Making sure the solar energy panel is laid outdoors under the sunshine
Connecting the load at the end. if inversely connected, the led lamp may be damaged
Please pay attention to the anode and the cathode to avoid the inverse connection.

• Pls buy with confidence
• Shipping
• Payment
• About us
• customer service

Pls buy with confidence

We are spending more than  6 years in eBay business, we promise, we are an Honest and Hard-working seller, we do love our Job, we already try our best to provide best services.
 
Hope you enjoy your purchase in our store
 
 If any questions and ideas, just feel free to tell us ,we are here for you or will be back to you within 24 hours.
 
 Our reputation for excellent customer service has been built over 5 years of trading by providing great value and support to all of our customers. With tens of thousands of products shipped,we understand the things that matter to you, the buyer.

Shipping

• We ship to Paypal registered address only!

• Items will be shipped within 24 hours after payment received.

• For Items that shipped from China is send by Airmail, it normally take 15-35 days for delivery

• For Items that shipped from UK warehouse is send by Royal Mail
  , it normally take 2-5 days for delivery, and no tax to The European Union!!!
  

• If you do not receive your item after 35 days. please contact us immediately for further assistance. We will be responsible for any damages or losses incurred in the shipping process.

• Import duties, value added taxes and any other charges are NOT included in the item price or shipping costs. As an eligible importer,you are responsible for any reasonable tax or any other importation fees.

Payment

• W e accept paypal only !
•  
• Payment must be received in 5 business days .
• Please leave note for your special request (e.g. Colors or Size) in PayPal when you pay the order.
• Any special request cannot be accepted after 24 hours of payment, because most of orders will be processed instantly and same day dispatched.

About us

• Specialized in electronic components and moudels.
• Real store, Goods in stock.
• Competive price. Good quality

We have more than 8 years experience in international business.have a wealth of experience in shipment. and we work with reliableshipment company, can get good price from DHL in Hongkong. customer service

1. We take care of all requirements from every single valued customer, like you. Therefore, we do our best to control the quality of each item before sending.

2. In very rare case, if the product is found faulty, please contact us for return or refund.

3. In addition, we offer 30 days unconditional Refund Warranty and 1 Year Manufacturer Warranty.

4. We must be informed if you do not like the device within 7 days upon receiving the item and we will give you a returned merchandise authorization number (RMA). Without (RMA), the buyer will be responsible for any loss of return.

5. All returns must include all original items undamaged, in re-saleable condition, all original packaging including manuals, warranty forms, etc.

6. As we are selling all items on eBay from factory at lowest price, we are unable to refund you shipping and handling costs. Buyer is responsible for shipping costs incurred shipping products back.

go to my store

 

---

Am 17.10.19 hat der Verkäufer die folgenden Angaben hinzugefügt:

 

•  
•  
•  
•  
•  
•  

---

Am 18.01.2024 hat der Verkäufer die folgenden Angaben hinzugefügt:

• Condition: Neu
• select: 6V 12V 3A
• Brand: GCSUPERMARKET
• Marke: Markenlos
• Material: Plastic

Siehe Mehr