STEPPERONLINE 12Nm Nema34 Closed Loop Stepper Servo Motor Driver CL86T V41 Kit.
This Closed-loop Stepper offers an alternative for applications requiring high performance and high reliability when the servo was the only choice, while it remains cost-effective. The system includes a 2-phase stepper motor combined with a fully digital, high performance drive and an internal encoder which is used to close the position, velocity and current loops in real time, just like servo systems. It combines the best of servo and stepper motor technologies, and delivers unique capabilities and enhancements over both, while at a fraction of the cost of a servo system.
Closed Loop Stepper Motor + Driver Kit included:
- 1 x Closed Loop Stepper Driver 0-8.2A 24-80VDC for Nema 34 Stepper Motor CL86T V4.1
- 1 x Nema 34 Closed Loop Stepper Motor 12.0Nm(1699.68oz.in) Encoder 1000CPR
- 1 x 1.7m Long Encoder Extension Cable for Closed Loop Stepper Driver
- 1 x RV-4 AWG18 1.7m Long Motor Extension Cable with GX16 Aviation Plug
- 1 x RS232 Debugging Cable
Motor Specification
Model
| 34HS59-6004D-E1000
|
|
Phase Number
| 2
|
Step Angle
| 1.8deg
|
Holding Torque
| 12Nm
|
Rated Current
| 6A
|
Phase Resistance
| 0.7(Ohm)
|
Inductance
| 7.9 mH ± 20%(1KHz)
|
Number of Leads
| 4
|
Shaft Diameter
| 14mm
|
Shaft Length
| 37mm
|
Keyway Shaft Length
| 25mm
|
Lead Length
| 300mm
|
Encoder Specification
Output Circuit Type: Differential type
Encoder Resolution: 1000
Output Signal Channels: 2 channels
Supply Voltage Min: 4V
Supply Voltage Max: 5V
Output Current: 100mA
Output High Voltage: 5V
Output Low Voltage: 4.5V
Output Frequency Max: 60kHZ
2-Phase Hybrid Stepper Servo Driver CL86T
350W 60V 5.9A 115/230V Switching Power Supply
Key Features
60V DC 5.9A output
AC input voltage range: 93~132V/176~264VAC
115V/230V AC selected by switch
High efficiency low cost
Forced air cooling by built-in DC fan
Low output ripple and yawp
Over current, over voltage, short circuit and overheat protections
215*115*50mm (L*W*H)
Am 22.02.2024 hat der Verkäufer die folgenden Angaben hinzugefügt: